Washer & Drying Table Combination
A barrel washer and a 20-roller drying table on one machine, so every wet transition drains into one tank and is managed in one place. Built with 3 or 4 metre barrels at 1200 or 1500 mm diameter.
Barrel Washer
A stainless steel barrel washer in lengths from 3 to 9 metres and 1200 or 1500 mm diameters, sized to your volume and to how dirty the crop comes in.
The barrel washer is the core of an HJV wash line. Product tumbles through a rotating stainless barrel lined with a "D" mold rubber spiral, a fresh water rinse bar finishes it on the way out, and an auger base tank carries settled dirt away.
Barrel length sets how long product spends in the wash, so we size it to your throughput and soil. 3, 4 and 5 metre barrels come in 1200 mm (48") or 1500 mm (60") diameter; 6, 8 and 9 metre barrels in 1500 mm. Heavy clay or stony ground? Add an integral de-stoner, a sludge drag chain or pintle lining in the barrel.
Doors with safety locks and gas struts, hatches into the tank and split bearings on the top shaft keep cleaning and repairs short, so the line gets back to running sooner.
Why it works
Highlights
- 01
Full stainless steel construction
- 02
4 mm stainless barrel
With a "D" mold rubber spiral.
- 03
Six barrel lengths
3 m (10') to 9 m (30').
- 04
Auger base tank
- 05
Access doors with safety locks and gas struts
Plus an electrically operated door with remote operation.
- 06
Split bearings on the top shaft
For easier maintenance.
Data
Models and sizes
| Barrel length | 1200 mm (48") diameter | 1500 mm (60") diameter |
|---|---|---|
| 3 m (10') | Yes | Yes |
| 4 m (13') | Yes | Yes |
| 5 m (16') | Yes | Yes |
| 6 m (20') | — | Yes |
| 8 m (26') | — | Yes |
| 9 m (30') | — | Yes |
Configure it
Options
Integral de-stoner
Floating debris removal
Air assist for floating debris removal
Drag chain for sludge and waste removal
Special rinse bar
Brush lining for the barrel
Full or half pintle lining
Video
See it running
Play video: HJV Engineering washer leaving for the USAWashing & stone removal
Works alongside
Pre-Soak Tank
Up to 125 tons (250,000 lb) per hour
Soaks product ahead of the washer so dirt loosens, stones drop and floating debris comes off early, at up to 125 tons per hour. It also holds product so the wash line gets an even feed.
De-Stoner
Takes stones and clods out at the start of the line, standalone or mounted on an HJV washer. 85% of the standalone unit's components move onto an HJV wash system if you add one later.
Planning a line? Talk to the HJV Engineering team.
Tell us what you run, how much of it, and where it goes next. We'll lay out the line with you.